ASTM C Standard Practice for Reducing Samples of Aggregate to Testing Size. Qty. Model, Description. 1, H, Sample splitter, 14 chutes, 1/2″ chute width. 1, H, Sample splitter, 14 chutes, 3/4″ chute width. 1, H, Sample. smaller test sample size required or convenient for each test. ASTM C provides procedures for reducing samples to the size required for testing. This process.

Author: Garan Malabei
Country: Albania
Language: English (Spanish)
Genre: Literature
Published (Last): 5 May 2016
Pages: 430
PDF File Size: 14.68 Mb
ePub File Size: 14.15 Mb
ISBN: 956-6-90513-335-2
Downloads: 34214
Price: Free* [*Free Regsitration Required]
Uploader: Sashura

Other factors being equal, larger samples will tend to be more representative of the total supply.

Chance inclusion or exclusion of only one or two particles in the selected test sample may importantly influence interpretation of the characteristics of the original sample. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Related Article:  TERAPIA CU INGERI DOREEN VIRTUE EPUB DOWNLOAD

ASTM C / CM – 18 Standard Practice for Reducing Samples of Aggregate to Testing Size

Historical Version s – view previous versions of standard. The alternative designation given in parentheses is for information only and does not represent a different standard sieve size.

This practice provides procedures for reducing the large sample obtained in the field, or produced in the laboratory, to a convenient size for conducting a number of descriptive and quality tests. Failure to carefully follow the procedures in this practice could result in providing a non-representative sample to be used in 7c02 testing.

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

These techniques are intended to minimize variations in measured characteristics between the test samples selected and the large sample.

The laws of chance dictate that these few particles may be unequally distributed among the reduced size test samples. Combining values from the two systems may result in non-conformance with the standard.

The individual test methods provide for minimum amount of material to be tested. Sieve size is identified by its standard designation in Specification E Link to Active This link will always route to the current Active version of the standard. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

Related Article:  1N4735A DATASHEET EBOOK DOWNLOAD

In these cases, the entire original sample should be tested. Substantial differences between the selected test samples sometimes cannot be avoided, for example, in the case of an aggregate having relatively few large size particles in the sample.

Similarly, if the test sample is being examined for certain c7022 occurring in only small percentages, caution should be used in interpreting results from the reduced size test sample.